Well I finished my Dragon Tooth and I must say it turned out better than I expected.
The Dragon tooth is about a foot tall and about 9 or 10 inch round at the root. The Dragon Tooth was designed to look like it was pulled from a large Dragons Jaw after the Dragon had been dispatched by a might party of adventures. This Dragon tooth build was done from scratch and is a one of a kind build. I am looking at making a second one that I will mold and cast and add some fancy glowing ruins too while i can then also offer a lower cost piece as well.
If the Dragon Tooth doesn’t sell at a local show over the next few weeks I’ll have it listed over at Etsy where you can purchase it to add to your gaming room trophy wall. Which is something I think every good gamer should start making.
If you would like to see it in person I’ll have it at the Oddmall on October 31st and November 1st.
Here are some pictures of the finished Dragon tooth.
As always if you have any questions please feel free to contact me..
Steve